The Outlaw is the first dual pedal from Flattley pedals that combines the similarities of two of our pedals, The Ace tone booster and the Plexi overdrive. The boost section is a clean boost that also has a tone stack to allow it to be a bass boost, a treble boost or anywhere in between. The overdrive section is an FET based circuit that gives a simulation of the harmonic distortion that you would expect from a 12AX7 valve with a wide range between a sweet blues tone to a flat-out rock tone. Each of the two halves of the pedal has its own bypass footswitch to allow the user to use boost or overdrive individually. However, the combination of these two pedal circuits is taken further by allowing the user to swap the order of the two with the flip of a single switch. This means the overdrive tone can be boosted (with additional tone shaping) in one mode, ideal for lifting level for soloing. Alternatively, the overdrive circuit can be driven by the booster which can push it into extreme compression​/​ distortion as the boost half of the pedal has its own tone stack that can be used to pre emphasise the signal to give a wider range of overdriven tones. Toggle Switch: The toggle switch allows you to change the lead order of the two pedals. Toggle switch selected forward has the clean tone booster as the lead pedal, toggle switch selected to the rear has the plexi style overdrive as the lead pedal. Plexi Drive Controls Volume: Controls the overall output level. Gain: Controls the amount of gain​/​overdrive Tone: Controls the amount of treble​/​bass Tone Booster Controls Volume: Controls the output of the pedal from zero (use as a kill switch), unity gain is around midway and max gives quite a lift to the output. It’s second function is to act as a gain recovery stage for the tone control. Tone: Midway the tone control is effectively flat and the setting you would use for a straight lift in volume. Either side of midway there is a sweet spot allowing tone to be a little dark (anticlockwise) or have a bit more sparkle (clockwise). Tone fully anticlockwise, the pedal works as a bass boost, fully clockwise it becomes a treble boost with the volume control being used as a gain compensation control as bass boost requires a reduce in overall gain and treble boost usually requires an increase in overall gain. The Outlaw comes in a 1590BB Enclosure (LxWxD): 119 x 94 x 30 mm (67 x 3.68 x 1.18 inch) Standard negative centre,-9v dc tip power supply unit​/​power brick required No internal 9v dc battery function 15mm red anodised aluminium custom etched control knobs Red halo light rings installed The Outlaw comes with 2 red custom etched aluminium foot toppers This edition comes in red, holographic chrome metal flake and silver paisley skulls hydro graphics.